低温冷绕试验机英文版介绍

FZ-7401 低温冷绕试验机
CORD WINDING CRACK TESTER
UL1581，VDE，JIS-C3005
导体断面积 100mm2 以下之试料在本机内冷却 1 小时后，立即以均匀之速度将试样绕卷于规定直径之圆杆上，断面积 100mm2 以上之试料则先行绕卷，再冷却相同之时间后，立即以反方向绕卷于圆杆上。试验后取出试样，检视试样表面是否产生龟裂、裂痕。 
If the cross-sectional area of conductor is less than 100mm2，then specimen must be put into testing chamber for freezing for one hour，after that immediay rolls specimen around the specified rod in a uniform speed 。Otherwise，for the cross-sectional area over 100mm2，roll the specimen before hand and put into chamber for freezing one hour。Afterwards，immediay roll specimen around the rod in reverse direction。Finally，take out of specimen for checking whether its surface has crack or fissure or not。 

　

内箱尺寸 Interior dimension	50x60x50cm
冷却方式 Air-change rate	气冷式 Air Frozen
温度控制器 Temp. controller	PID 数位设定 PID digital setting
温度范围 Temperature range	室温 Room temp. ~ - 40℃
控温精度 Accuracy	±1℃
夹具   Grips	3 组 (sets)
圆杆   Rod	试料厚度的 1.5~2倍1.5 ~ 2 times the thickness of specimen
材质   Material	内胆外箱均为 SUS304# 不锈钢
电源   Power	AC380V / 50Hz